ChargePoint Home Flex Hardwired Level 2 EV Charger, J1772 (CPH50-HARDWIRE-L23) vs EVIQO EVIPOWER J1772 40A NEMA 14-50 Plug-In Level 2 EV Charger
These are side-by-side facts taken from each product guide: published specifications, strengths and caveats as their sources state them. This page is not a test, a ranking or a verdict about which model is better.
ChargePoint Home Flex Hardwired Level 2 EV Charger, J1772 (CPH50-HARDWIRE-L23)
A hardwired circuit where you want to pick the amperage to suit the panel
Home Flex is set at install to match your circuit, anywhere from 16 to 50 amps, with ChargePoint publishing the circuit-to-load table. This hardwired J1772 version can reach the 50-amp maximum, which needs a 70 or 80-amp circuit, and it is the configuration ChargePoint points to for outdoor mounting.
Published specifications
- Guide: 50A max load on an 80A or 70A circuit; 48A on 60A; 40A on 50A; 16A on 20A
- Guide: continuous load device, circuit must be rated for 125% of maximum load
- Guide: dedicated 240V two-pole non-GFCI breaker; 90°C copper, max 6 AWG, terminal to 105°C
- Guide: operating range -40°F to 122°F at 16-48A, -40°F to 113°F at 50A
- Guide: mount centre 39-43 in above the floor; Wi-Fi signal required at the location
- Guide: 3-year parts exchange warranty, original purchaser, single-family residence
Strengths
- Maker publishes the full circuit-rating to maximum-load table, so sizing is checkable
- Wide operating temperature range, down to -40°F at settings up to 48 amps
- Hardwiring unlocks the 60, 70 and 80-amp circuit ratings a plug cannot use
Caveats
- Warranty excludes on-site labour to uninstall or reinstall the station
- No enclosure NEMA or IP rating appears in the guide or product page we read
- Some app functions and troubleshooting need Wi-Fi at the charger's location
Read the full ChargePoint Home Flex Hardwired Level 2 EV Charger, J1772 (CPH50-HARDWIRE-L23) guide
EVIQO EVIPOWER J1772 40A NEMA 14-50 Plug-In Level 2 EV Charger
An existing EV-graded NEMA 14-50 outlet on a dedicated 50-amp circuit
The plug-in EVIPOWER delivers 40 amps through a J1772 connector on a 25-foot cable, in an IP66 and NEMA 4 housing rated from -22°F to 131°F. It needs an EV-graded NEMA 14-50 outlet on a dedicated 50-amp circuit, and EVIQO's warranty specifically excludes failures where that receptacle was not used.
Published specifications
- Guide: 40A output requires an EV-graded NEMA 14-50 outlet on a dedicated 50A circuit
- Guide: a 40A circuit gives 32A; the internal switch cannot raise the plug-in past 40A
- Data sheet: 208-240V AC 60 Hz, J1772 connector, 25 ft output cable, 37 in input cable
- Data sheet: NEMA 4 / IP66; operating -22°F to 131°F; storage -40°F to 167°F
- Data sheet: UVP, OVP, RCD (CCID20), SPD, ground fault, OCP, OTP protections
- Warranty: 3 years parts exchange, original purchaser, residential, USA and Canada
Strengths
- Plugs into an existing 14-50 outlet, so it can move with you
- IP66 and NEMA 4 housing with a wide stated operating temperature range
- App gives 6 to 40 amp adjustment, scheduling and per-session energy tracking
Caveats
- EVIQO's FAQ says no electrician is needed while its guide asks for permits and code compliance
- Warranty names failure to use an EV-graded 14-50 receptacle as an exclusion
- Plug and Charge must be disabled before schedules or delayed start will run
Read the full EVIQO EVIPOWER J1772 40A NEMA 14-50 Plug-In Level 2 EV Charger guide
How to choose between them
Choose the ChargePoint Home Flex Hardwired Level 2 EV Charger, J1772 (CPH50-HARDWIRE-L23) if your situation matches: A hardwired circuit where you want to pick the amperage to suit the panel. Its main caveat: Warranty excludes on-site labour to uninstall or reinstall the station.
Choose the EVIQO EVIPOWER J1772 40A NEMA 14-50 Plug-In Level 2 EV Charger if your situation matches: An existing EV-graded NEMA 14-50 outlet on a dedicated 50-amp circuit. Its main caveat: EVIQO's FAQ says no electrician is needed while its guide asks for permits and code compliance.
Both entries repeat what each guide records. Confirm the model, included parts and availability on the current listing before ordering.
Primary sources
- ChargePoint Home Flex 16A-50A installation guide (75-001336-01 r9), supplied with the listing Source for ChargePoint Home Flex Hardwired Level 2 EV Charger, J1772 (CPH50-HARDWIRE-L23)
- ChargePoint Home Flex product page with configuration comparison Source for ChargePoint Home Flex Hardwired Level 2 EV Charger, J1772 (CPH50-HARDWIRE-L23)
- EVIQO EVIPOWER Smart EV Charger installation guide, supplied with the listing Source for EVIQO EVIPOWER J1772 40A NEMA 14-50 Plug-In Level 2 EV Charger
- EVIQO EVIPOWER plug-in frequently asked questions sheet, supplied with this listing Source for EVIQO EVIPOWER J1772 40A NEMA 14-50 Plug-In Level 2 EV Charger
Primary sources checked .