Space heater guide
Pelonis PHF15RSAPH30 30-inch Ceramic Tower Heater
A room where the heater can have its own circuit and three feet clear in front
A 30-inch PTC ceramic tower with 900 and 1500-watt settings, ECO thermostat mode from 41 to 95 F, fan-only mode, oscillation, a 0-12 hour start or stop timer, a remote, a tip-over switch and a 15-hour idle shut-off. It draws 12.5 amps, needs a wall outlet on its own circuit and carries a one-year warranty.
Listing checked . Confirm the model, included parts and availability before ordering.
Published specifications
- Manual: 120 V 60 Hz; Low 900 W, High 1500 W; draws 12.5 A
- Manual: modes High, Low, ECO, fan; set temperature 41-95 F in ECO
- Manual: timer 0-12 h start or stop; auto shut-off after 15 h idle
- Manual: tip-over switch; FF shutdown above 122 F; E1/E2 sensor codes
- Manual: 3 ft (0.9 m) clear in front; remote works within 16 ft
- Listing: 30 in tall, 7.09 x 6.93 in, 7.09 lb; manual: 1-year warranty
Fit and limits
Strengths
- Tip-over switch plus an automatic shut-off after 15 hours with no button pressed
- Timer can delay the start as well as stop the heater, from 0 to 12 hours
- Four modes including fan-only, with a remote that mirrors the panel
Caveats
- Manual gives a set temperature for ECO only and says control is not accurate
- Needs a circuit with nothing else running on it, and no extension cord or strip
- One-year warranty with the buyer paying shipping both ways
A 30-inch PTC fan heater with a remote and two heat levels
Pelonis's manual calls the PHF15RSAPH30 a PTC fan heater. Its specification table lists two power levels, 900 watts on Low and 1500 watts on High, with the same figures with oscillation on, on a 120-volt, 60 Hz supply. The listing's details table says 110 volts; the manual says 120.
The listing gives the tower as 30 inches tall and 7.09 by 6.93 inches, and 7.09 pounds, and names the included parts as the heater, user manual and remote control. Pelonis's product page showed no specification data when we read it, so treat those figures as listing data.
The manual says the remote takes a 1.5-volt AAA battery and works within 16 feet (5 m) and 30 degrees of the control panel. It warns against mixing old and new batteries or different battery types. The sources we read do not say whether a battery comes in the box.
Four modes, and a set temperature in ECO
The function button cycles High, Low, ECO and fan-only, in that order, and the heater starts on High when switched on. This is the key detail for buyers: the manual describes setting a temperature only for ECO mode, and it does not describe a set temperature for High or Low.
In ECO you can set 41 to 95 degrees Fahrenheit. The manual says the heater stops and goes to standby once the room is four degrees above your setting, and starts heating again when the room falls below it. It adjusts its heat level by comparing room and set temperatures. The listing's table gives a 40-degree minimum, one degree below the manual.
The manual adds a caution worth taking literally: this heater cannot achieve accurate temperature control and must not be used as a temperature-control device for storage areas, animals, plants or similar spaces. Oscillation has its own button and stops whenever the heater stops heating.
Timer, 15-hour shut-off and the on-screen codes
The timer works in two directions. With the heater running you can set a timed stop from 0 to 12 hours; with it on standby you can set a timed start in the same range. Pelonis's page and the listing both describe this as a 12-hour timer.
Separately, the manual describes a forced shutdown: if the heater runs for 15 hours with no button pressed, it switches itself off. The manual lists this shutdown separately from the 0 to 12 hour timer described above.
The display reports faults with codes. E1 or E2, with the buzzer sounding and the buttons locked, means a temperature sensor fault. FF flashing means the heater has shut down because the room temperature it senses is above 122 degrees Fahrenheit, and only unplugging clears it. The troubleshooting table adds that a sudden shut-off during heating points to the thermal cut-off, after which you unplug it and let it cool.
Tip-over switch, three feet of clearance and bathrooms ruled out
The manual confirms a tip-over switch and explains how to restart the heater after it trips. It asks for combustible materials to be kept at least three feet (0.9 m) from the front and away from the sides and rear, without giving a side or rear distance.
It is not for bathrooms, laundry areas or similar indoor locations, not for outdoor use, and not near flammables. The manual says not to stand it on soft surfaces and never to block the air intakes.
The manual also carries burn and overheating warnings and cautions about use near children and people who need care, including a caution against leaving it unattended. This guide does not summarise them; read those passages in the manual itself before first use.
12.5 amps, a wall outlet and nothing else on the circuit
The manual states that the heater draws 12.5 amps while running and says not to plug it into a circuit that already has other appliances or electronics working. It must go directly into a wall outlet; extension cords and power strips are ruled out, and the plug is polarized.
Before first use it asks you to check the power cord and to confirm your outlet is a grounded 120-volt socket. The manual sends you to a qualified electrician about a loose outlet.
The manual says to keep the cord out from under carpets, rugs and furniture. To disconnect, turn the heater off first and then pull the plug, never the cord. The listing's bullet that it needs no adapter or extension cord matches the manual's rule to plug it straight into the wall.
Cleaning once a season, and a one-year warranty
Pelonis recommends cleaning at least once during the heating season. The manual allows only a dry cloth on the outside of a cool, unplugged heater, rules out cleaning agents, detergents and immersion, and leaves any other maintenance to an authorised representative. It suggests keeping the original packaging for off-season storage.
The manual's warranty is one year from the date of original purchase against defects in materials and workmanship, for the original buyer or a gift recipient, with the original receipt required. Pelonis repairs or replaces at its option, but you pay the cost of shipping the product in both directions. Normal wear, misuse, accidents and use outside a single-family household are excluded.
Several listing claims have no support in the manual: that it heats to 70 degrees in three seconds, that it covers 280 square feet, that it runs below 55 decibels, and that it has 26 percent more vents. Pelonis's product page repeats them as marketing; no test conditions are given, and we did not measure anything.
Check the current listing
Confirm the model, included parts and availability before ordering.
Primary sources
- Pelonis US product page for the 30-inch ceramic tower heater PHF15RSAPH30
- Pelonis US product-support page for PHF15RSAPH30
- Pelonis owner's manual for PHF15RSAPH30 (PDF)
Primary sources checked .
Compare with
- De'Longhi EW7707CM ComforTemp Oil-Filled Radiator Heater
A room of at least 43 square feet where you want fanless, oil-filled radiant heat
- Lasko 751320 23-inch Ceramic Tower Space Heater
A bedroom or office corner with a free wall outlet and three feet clear in front
- Dr Infrared Heater DR-968 1500W Infrared Cabinet Heater
A main living room or home office with its own circuit and three feet clear front and back
- Lasko MyHeat 101 200-Watt Personal Ceramic Heater
Warming your feet and legs at a desk without loading the circuit
- Dreo Atom One DR-HSH004 1500W Ceramic Space Heater
A desk or bedside spot within cord reach of a wall outlet, with three feet clear in front
- Lasko 5775 23-inch Oscillating Ceramic Tower Heater
A room within Lasko's 150 sq ft figure, near a free wall outlet
Side-by-side pages, this model next to: De'Longhi TRD40615E Dragon Digital Oil-Filled Radiator Heater, Lasko 5586 Digital Ceramic Tower Heater with Remote.