Plain Buy Guides

As an Amazon Associate I earn from qualifying purchases. Links to Amazon on this page are affiliate links.

Robot Vac Reality product guide

Roborock Qrevo S Pro Robot Vacuum and Mop with Multifunctional Dock

Hard floors where a four-foot clear run in front of the dock is possible

A LiDAR robot with dual spinning mops and a dock that empties, washes, dries and refills. The robot is 3.80 inches tall, but the manual asks you to keep 1.2 m of depth clear in front of the dock. Roborock's 167F figure is measured at the heater output, not at the mop.

Check this model on Amazon

Listing checked . Confirm the model, included parts and availability before ordering.

Published specifications

  • Maker page: robot 13.78 x 13.90 x 3.80 in; dock 13.39 x 19.17 x 20.43 in
  • Manual: reserve 1.2 m depth, 0.9 m height and 0.4 m width for the dock
  • Maker footnote: 167F is the internal heater output, not the mop temperature
  • Maker page: 10 mm mop lift, 200 RPM only at extreme water flow, 30 flow levels
  • Manual: mop cloths replaced every 1-3 months; filter and dustbin need 24 h to dry
  • Manual: 2.4 GHz Wi-Fi only; Roborock says the app is required to work as intended

Fit and limits

Strengths

  • Dock empties, washes with heated water, warm-air dries and refills the robot
  • 3.80-inch robot height with a 10 mm mop lift for moving on and off carpet
  • Maker footnotes every performance claim and cites SGS numbers for tangling and filtration

Caveats

  • Dock wants 1.2 m of clear depth plus a hard floor flat against a wall
  • 167F is measured at the heater output, so it is not the mop's wash temperature
  • Carpet deep-clean and avoid settings must be enabled by hand in the app

A full-service dock: empty, wash, dry and refill

The Qrevo S Pro pairs a LiDAR robot with what Roborock's manual literally calls an Empty Wash Fill Dock, model EWFD24LRR. That dock empties the robot's dustbin into a disposable bag, washes the two spinning mop pads with heated water, dries them with warm air and refills the robot's onboard water from a clean tank, with a separate dirty tank you pour out. The robot itself is model RRE0PEE; the listing and Roborock's site call the pairing Qrevo S Pro.

Amazon's included-components field lists the robot, the multifunctional dock, a dock base, a power cable, a rotating mop module set and a user manual. It does not name spare mop cloths, a spare filter or a dust bag, so confirm the consumables in the offer you pick rather than assuming a starter set.

Mop washing is automatic and decided by the robot: the manual says it returns to the dock for washing and refilling on its own during a clean, and that you can change the wash frequency and mode, or trigger a wash, in the app. Drying starts as needed after washing or cleaning, and its duration can be changed or turned off in the app.

Where the 167F is actually measured

Amazon's first bullet says 167F high-temperature self-cleaning helps refresh the mops. Roborock's own footnote is narrower, and it matters: the stated 167F refers to the temperature measured at the internal heater output, not the temperature of the mop itself. So it is not a claim that your mop pads are washed at 167F.

The warm-air drying number has a condition too. Roborock says the air around the mop can be heated up to 113F during drying in a 77F room, from internal testing. The quoted 45 dB drying noise was measured in a semi-anechoic chamber, which is a laboratory condition rather than a living room.

The manual adds two safety notes about the heat and water that do not appear in the listing: do not touch the drying air outlets, to avoid burns, and during and shortly after mopping the floor will be wet and slippery, so adjust the water flow to the floor type and conditions and do not walk on it until dry.

The dock needs a defined box of space

Roborock's specifications give the robot as 13.78 by 13.90 by 3.80 inches and the dock as 13.39 by 19.17 by 20.43 inches. Amazon's item dimensions of 13.38 by 19.17 by 20.51 inches are the dock, not the robot, so use the 3.80-inch figure when you measure under furniture. Roborock's page states the same thing metrically as a 9.65 cm slim design.

The manual's installation section is unusually precise about clearance: place the dock on a hard, flat floor such as wood, tile or concrete, flat against a wall, and reserve at least 0.9 m (2.96 ft) of height, 0.4 m (1.32 ft) of width and 1.2 m (3.94 ft) of depth. The 1.2 m of depth in front is the figure that surprises people, because it is nearly four feet of floor the robot needs kept clear.

Two placement warnings follow: putting the dock on a soft surface such as carpet or a mat may make it tilt and cause docking problems, and direct sunlight or anything blocking the dock location beacon can stop the robot finding its way home. The dock also must not be run without its clean water tank, dirty water tank, dust container cover, dust bag, cleaning tray filter or cleaning tray in place.

Mopping, carpet and the numbers behind the claims

The mops are two spinning pads that lift for carpet. Roborock says the maximum rotating speed is 200 RPM, and that figure applies only when you select extreme water flow in custom mode; there are 30 water-flow levels. The mop modules lift up to 10 mm, which is the maker's figure from internal testing, and the robot uses a carpet sensor to decide when to raise them.

Carpet behaviour is not automatic out of the box. Roborock's own page carries a note that the carpet cleaning settings, whether to deep clean carpets with boosted suction and the mop lifted or to avoid rugs entirely on edge-cleaning paths, must be manually enabled and selected in the Roborock app. The manual also says not to use the product on high pile carpets and that effectiveness may be reduced on dark carpets.

The 18,500 Pa suction is Roborock internal testing for a maximum, with a footnote saying actual results vary and that suction values may differ by country or region. Two anti-tangle and filtration claims do cite SGS certificates, numbers PT/24/GEN/0455/3 for a 0 percent hair tangling rate and PT/23/GEN/0047/1 for a 99.9 percent pollen filtration rate; we did not read either certificate and are reporting Roborock's description of them.

What you still have to do by hand

Filling and draining are manual. The manual tells you to lift the clean water tank out, fill it with cold tap water only, and put it back, and to empty and rinse the dirty water tank as required. Only Roborock-recommended cleaning solution is allowed, no disinfectant, and the manual warns against adding too much solution because the robot can slip.

The manual's replacement intervals are specific. Main brush: clean every two weeks, replace every 6 to 12 months. Side brush: clean monthly, replace every 3 to 6 months. Washable filter: clean every two weeks, replace every 6 to 12 months, and allow at least 24 hours to dry. Mop cloths: clean as required, replace every 1 to 3 months, which is the shortest interval in the list. The dustbin is washed with clean water only and also needs 24 hours to dry. The cleaning tray and its filter are rinsed as required, and the dust bag is replaced as required.

That 24-hour drying rule applies to both the filter and the dustbin, so a thorough wash takes the robot out of service for a day unless you keep spares.

App, network and the figures nobody publishes

Roborock states plainly on its own page that use of this product requires the Roborock app and that the product will not function as intended without downloading it and agreeing to its terms. The listing and the manual both say only 2.4 GHz Wi-Fi is supported. Alexa, Siri and Google Home are listed as compatible, and Matter support is described as coming through a future over-the-air update rather than being present today.

Do Not Disturb defaults to 22:00 to 08:00, and the manual warns that during DND the robot will not auto top-up its charge. Scheduled cleaning only starts above 15 percent battery. If a clean finishes in under ten minutes the robot cleans the area twice. Spot cleaning covers a 1.5 by 1.5 m square centred on the robot.

Some listing table figures have no maker counterpart and should not be relied on: Battery Life 180 minutes, Voltage 120 volts (that is the dock's input), Capacity 2.7 liters and Noise Level 60 db. Roborock's own noise figures are under 55 dB in mop-only mode and under 60 dB in sweep-only quiet mode, both from internal testing, while Amazon's bullet compresses this to a flat 55 dB. On bag life the listing says a 2.7 L bag lasting 7 to 9 weeks while Roborock's page says up to 65 days; both are internal-testing claims and they do not agree. Nothing we read gives a water-tank volume, a dustbin volume or a threshold climbing height, and the manual contains no warranty text, so we did not summarise warranty conditions. Check the seller and condition of the offer you select.

Check the current listing

Check this model on Amazon

Confirm the model, included parts and availability before ordering.

Primary sources

  1. Roborock Qrevo S Pro product page with specifications and claim footnotes
  2. Roborock Qrevo S Pro Series user manual supplied on the listing (robot RRE0PEE, dock EWFD24LRR)

Primary sources checked .

Compare with

Keep comparing

Use the Robot Vac Reality product index to compare other models, or read the full buying guide for category-level advice.