Robot vacuum guide
ILIFE A30 Pro Robot Vacuum and Mop with Self-Empty Station
Hard floors and low rugs under 18 mm, with 1.5 m clear in front of the station
A LiDAR robot vacuum with a 200 ml mop tank you fill by hand and a compact station that empties the dustbin into a 2.5 L bag. ILIFE rates it at 10,000 Pa, with a 20 mm threshold limit and rugs over 18 mm to be avoided.
Listing checked . Confirm the model, included parts and availability before ordering.
Published specifications
- Manual: robot 330 x 330 x 95 mm, 2.7 kg; station P200 285 x 145 x 253 mm
- Manual: station needs 1.5 m clear in front and 0.5 m on both sides
- Manual: 0.2 L dustbin and 0.2 L water tank; no hot water or cleaning agents
- Manual: avoid rugs over 18 mm; climbs thresholds up to 20 mm
- Runtime: 150 min on the listing vs over 180 min on ILIFE's page
- Manual: filter unwashable; charge time under 300 minutes
Fit and limits
Strengths
- Small 285 x 145 mm station that bags the dust after every run by default
- Manual gives clear limits: 18 mm rugs, 20 mm thresholds, -5 to 40 C operation
- Remote control included alongside app and voice control
Caveats
- Mopping is manual: fill a 200 ml tank, fit the pad, then wash and dry it; no mop lift
- Runtime is 150 min on the listing but over 180 min on ILIFE's page
- Station still needs 1.5 m clear in front and 0.5 m each side
A LiDAR robot with a small bag-type emptying station
The A30 Pro is a LiDAR-navigating robot vacuum that also mops, sold with a self-empty station. The manual's specifications name the robot model A30 Pro, and its safety section names the auto-empty station as model P200. The listing's box list is the station, 5 disposal bags, a charging adapter, the 2-in-1 water tank, a mopping support, 2 mopping cloths, a remote control, a side brush, a high-efficiency filter and the user manual.
The station only empties the dustbin. The manual says it starts dust collection automatically once the robot's charging pins have been aligned for 3 seconds, and runs its fan for about 15 seconds. ILIFE's page describes it as 12,000 Pa cyclone dust collection into a 2.5 L bag, although its own specification table prints station suction as 120000 Pa; the two figures appear on the same page.
The station is small by ILIFE's numbers: 285 by 145 by 253 mm and 2.0 kg, with a 120 V 60 Hz input. The robot measures 330 by 330 by 95 mm and weighs 2.7 kg, so it is about 3.7 inches tall, which matches Amazon's 3.74-inch height.
The station needs more floor than its footprint
The manual's placement guidelines ask for a hard, flat surface against a wall, with no obstacles within 1.5 meters in front and 0.5 meters on both sides. That clear area is far larger than the station's own 285 by 145 mm footprint, so measure the space, not the station.
It also asks you to avoid strong sunlight and reflective surfaces near the station, and to keep it away from where pets sleep because of the noise. The robot should be stored on the powered station in daily use, and the manual says to keep the charging pins on both the robot and the station clean to avoid poor contact.
Auto-emptying defaults to running after every cleaning session, with options for every second or third session. The manual notes that the station may not empty if the last cleaning task lasted less than 5 minutes.
Mopping is a hand-filled 200 ml tank
The A30 Pro uses a 2-in-1 unit that combines a 0.2 L dustbin with a 0.2 L water tank, which the listing also gives as 200 ml each. You fill the tank with clean water by hand; the manual suggests purified water to reduce limescale and says not to use hot water or cleaning agents, which may damage or clog the tank.
Fitting the mop bracket switches the robot into mop mode automatically, and the listing says removing the bracket gives vacuum-only cleaning. The manual says to watch the water level and refill when low, and to remove, wash and dry the mop after each use.
The manual is explicit that the mop should not be used on carpets and suggests zoning carpets out in the app while mopping. ILIFE's page describes the matching No Mopping Zone, where you designate carpet areas for the robot to avoid while mopping. Nothing in either source describes a mop lift.
Rugs, thresholds and where not to run it
The pre-cleaning notes set two physical limits: avoid high-pile or thick rugs over 18 mm (0.71 in), and the robot can climb thresholds up to 20 mm (0.79 in). The safety section adds that it is not suitable for high-pile carpets or certain dark-coloured carpets.
The manual asks you to fold rug tassels underneath and to use physical barriers or app no-go zones around fireplaces, vents and staircases. It warns that the anti-drop sensors can perform worse on dark carpets, reflective surfaces or when the sensors are dirty.
Operating conditions from the safety section: indoor home use only, not on wet or flooded floors, and not in extremely hot (above 40 C) or cold (below -5 C) conditions. The manual also says not to run it in a room where an infant is sleeping.
Runtime, bag life and suction claims do not all match
Runtime: the listing says up to 150 minutes in gentle suction mode, while ILIFE's page says over 180 minutes in silent mode covering 120 square metres. The manual pages we read give no runtime, only a charging time of under 300 minutes. We are reporting both figures; the documents do not reconcile them.
Bag life: the listing claims up to 280 days of hands-free cleaning with 5 dust bags, while ILIFE's page says a single 2.5 L bag lasts up to 7 weeks. Suction is 10,000 Pa on both the listing and ILIFE's page, which also says carpet detection boosts suction to that level; no test method is stated.
When the battery runs low, both the listing and ILIFE's page say the robot returns to the station, recharges and resumes where it left off. For long-term storage the manual says to charge fully, power off and recharge every 3 months.
Maintenance, app and warranty
The manual notes that the filter is unwashable, and its maintenance table sets clean and replace intervals part by part, with replacement intervals ranging from every 1 to 1.5 months to every 6 months. It also asks you to check the metal filter inside the bottom of the station for clogging.
The listing says the app works on 2.4 GHz Wi-Fi only. ILIFE's page lists custom areas, to-go and no-go zones, No Mopping Zones and multi-floor mapping, plus four cleaning modes: Plan, Edge, Spot and Max. A remote control is included, and the listing and ILIFE's page both name Alexa and Google Assistant.
Amazon's warranty field says 1 year manufacturer. We did not read ILIFE's warranty terms, so the conditions and the claim route are not covered here; the manual pages we read do not set them out either.
Check the current listing
Confirm the model, included parts and availability before ordering.
Primary sources
- ILIFE global product page for the A30 Pro with specifications
- ILIFE A30 Pro user manual supplied on the listing
Primary sources checked .
Compare with
- eufy RoboVac 11S MAX Robot Vacuum Cleaner (T2126)
Low furniture and hard floors, with no app or account involved
- Shark AI Ultra AV2511AE Robot Vacuum with XL Self-Empty Base
People who want self-emptying without buying dust bags
- Roborock Q10 S5+ Robot Vacuum and Mop with Auto-Empty Dock
Hard floors and low-pile carpet, with a wall run free for the dock
- iRobot Roomba 105 Vac Robot Vacuum
A simple LiDAR vacuum where you do not mind emptying the bin
- Roborock Qrevo S Pro Robot Vacuum and Mop with Multifunctional Dock
Hard floors where a four-foot clear run in front of the dock is possible
- Roborock Saros 10R Robot Vacuum and Mop with Multifunctional Dock 4.0
Low furniture and hard floors, with room for a 1.2 m deep dock slot
Side-by-side pages, this model next to: Roborock Q7 M5+ Robot Vacuum and Mop with RockDock Plus, Tapo RV50 Pro Omni Robot Vacuum and Mop with All-in-One Dock.